Following the success of the EDC/iCF 4000 series launched two years ago, InnoDisk once again leads the industry with the proud release of its latest high-speed industrial IDE flash module - EDC/iCF 8000 series. This new series was launched in the 2009 Embedded World held in Nuremburg, Germany last week. The new EDC/iCF 8000 series adopts the IDE/ATA and CF interface design with a maximum support of the UltraDMA 6 allowing a read/write transfer rate of 80MB/75MB. The maximum capacity of the new EDC/iCF 8000 series is 16GB which is currently the largest in all industrial flash modules

Two years ago, most embedded industrial IDE flash modules were designed as single channel supporting PIO mode or MwDMA mode with a transfer rate of only 24MB/sec or below. Market demand back then was focused on anti-vibration, anti-dust, space-saving, small capacity and low cost. With the rapid development of flash modules and the accelerated growth in application demands, dual-channel flash module with transfer rate at 45MB/sec supporting UDMA2 or UDMA4 was then designed. In the last 2 years, it is easier to see the fast-booting and high-speed performance application, so the dual-channel flash module was not able the meet market requirement anymore. InnoDisk now introduces the high-speed 8000 series integrating the memory management technology as quad-channel not only increasing the performance to 80MB/sec and supports UDMA5 and UDMA 6, but also shortening the booting time from 40 seconds down to 20 seconds. EDC/iCF 8000 series is absolutely the best solution for high-speed application requirements like medical devices, industrial PC and military equipments.

Due to limited of space, DOM products can only provide dual channels, which limits speed and capacity. However, InnoDisk 8000 series breaks through the restriction, as it comes with four channel designs, and ranges from 2GB to 16GB, which is significant innovation in the industry.

Apart from capacity and performance, in order to extend product life and satisfy various demands of the industrial market, Innodisk insists on the use of genuine SLC Flash IC, and guarantees each block is erasable more than 300 thousand times. Moreover, Flash IC can be used more than 10 years with the latest Global Wear-Leveling solution.

As with data protection, EDC/iCF 8000 series has passed 3000 times power cycling testing to ensure that data can be protected under different power surge situations. The EDC/iCF 8000 series have also passed different strict tests, including shock resistance test, drop test, temperature test; and have low power consumption and error correcting functions to ensure highest stability and reliability in different inferior environments.

InnoDisk provides total solution for storage and memory modules used in the industrial market, including FiD Series(Industrial SSD)、SATADOM Series(SATA 7pin Flash Module)、EDC/iCF Series(Embedded Flash Module)、Embedded USB Module、i-DIMM Series(Industrial DRAM Module…etc. In order to control quality and lead time, the flash modules are designed and manufactured in Taiwan, providing the best quality product and service to our clients.